FRONT & REAR PANELS

KEY

DESCRIPTION

39 MIC 1 GAIN

Adjust the level of the MIC1 Microphone Input

40 MIC 1 SOCKET

Connect a Microphone to this socket using a 1/4" cable/adapter

41 MIC 2 SOCKET

Connect an additional Microphone to this socket using a 1/4" cable/adapter

42 MIC 2 GAIN

Adjust the level of the MIC2 Microphone Input

43 MIC EQ

Adjust the Low and High Equalizer Bands of both the Microphone Inputs

44 MIC ON/OFF

Turn the Microphone Inputs on/off

45 SOURCE PC/LINE

Select the source sent to Mixer Channels 3 and 4. When in LINE position, the audio signal of the sources connected at the rear INPUTS will be routed to Mixer Channels 3 and 4. VirtualDJ Decks 3 and 4 will be muted in this case
When in PC position, the VirtualDJ Decks will be routed to those Mixer Channels
Led Indicators of the Source status available at the top panel

46 CF CONTOUR

Choose between Scratch /Cut and Smooth/Normal mode for the slope of the crossfader.

47 HEADPHONES SOCKET

Connect your Headphones using a 1/4" or a 1/8" cable or adapter

48 POWER

Connect the provided AC/DC Power Adapter and power on the unit with the Switch button

49 USB

Connect the N4 with a USB port of your computer using the provided USB cable

50 USB IN/TIMECODE

Set to TIMECODE position to route the Inputs to the USB Audio Interface (for DVS/timecode use)

51 Master OUT (XLR)

Connect your amplifier or your amplified speakers to these sockets using proper XLR cables. The Level of this Output is controlled by the Master Vol knob at the top panel of the unit

52 Master OUT (RCA)

Connect your amplifier or your amplified speakers to these sockets using proper RCA cables The Level of this Output is controlled by the Master Vol knob at the top panel of the unit

53 BOOTH OUT (RCA)

Alternative Output to connect speakers for monitoring using proper RCA cables The Level of this Output is controlled by the Booth Vol knob at the top panel of the unit

54 INPUTS 1/2

Connect external media sources such as Turntables, Cd Players, Media Players etc. Set the LINE/PHONO switchers to the appropriate position, depending on the source type. The routing of these inputs to the Mixer or the USB Interface depends on the SOURCE select and USBIN/TIMECODE switchers that the front panel of the unit

For further Technical features and specifications, visit
Numark N4
Product's Page

Hardware Integration Department 2016 - ATOMIX PRODUCTIONS

Reproduction of this manual in full or in part without written permission from Atomix Productions is prohibited.