mcs1234
V7 Pro User Here, using Behringer CMD-DC1 controller... I've mapped the whole thing successfully, but...
The knob I want to use for pitch is a rotary knob with circular LED pattern around it.
Mapping it as "Deck 1 pitch" works nicely (moving LED's too), but the incremental steps are a little large. The buttons available on the screen skin itself are smaller in increments (0.02%).
What the heck is the mapping command line for a rotary knob, but with smaller steps than the simple "pitch" command performs.
I think it's some kind of "variable" nomenclature, but I can't get anything to pass syntax editing. :-(
Thank in advance,
Doug
The knob I want to use for pitch is a rotary knob with circular LED pattern around it.
Mapping it as "Deck 1 pitch" works nicely (moving LED's too), but the incremental steps are a little large. The buttons available on the screen skin itself are smaller in increments (0.02%).
What the heck is the mapping command line for a rotary knob, but with smaller steps than the simple "pitch" command performs.
I think it's some kind of "variable" nomenclature, but I can't get anything to pass syntax editing. :-(
Thank in advance,
Doug
Mensajes Sun 18 Oct 15 @ 8:50 pm
PhantomDeejay
Try this:
param_multiply 50% & pitch
param_multiply 50% & pitch
Mensajes Mon 19 Oct 15 @ 12:29 am
mcs1234
Awesome. With that command, the LED sweep didn't work, so I gave it its own command ... perfect!
Thank you so much!
** Love the VDJ forum **
Thank you so much!
** Love the VDJ forum **
Mensajes Mon 19 Oct 15 @ 1:21 pm