kradcliffe
I have videoCrossfaderAuto selected which works well in 2 deck mode, however I have noticed when looping and mixing in a new track the transition starts when the incoming track fader is around the 30% mark.
If I have a loop running in the background depending on volume it brings in the new video instead of leaving the old one until I have completed the mix.
Is there a way of setting the incoming fader level before the transition cuts in?
If I have a loop running in the background depending on volume it brings in the new video instead of leaving the old one until I have completed the mix.
Is there a way of setting the incoming fader level before the transition cuts in?
Mensajes Fri 19 Jan 18 @ 2:56 pm
kradcliffe
Anything on this one?
Adion?
Adion?
Mensajes Wed 24 Jan 18 @ 1:55 pm
Adion
There's currently no way to adjust this level.
It depends on the selected transition if it will transition instantly at that point, or if it stops halfway and only completely moves to the next track after moving completely to the next track.
It depends on the selected transition if it will transition instantly at that point, or if it stops halfway and only completely moves to the next track after moving completely to the next track.
Mensajes Wed 24 Jan 18 @ 2:59 pm
kradcliffe
OK, thanks. I will check out some of the transitions to see what's best.
Mensajes Wed 24 Jan 18 @ 3:19 pm
Dan (djtouchdan)
Keith - not sure if this will help in what you are trying to accomplish.
http://www.virtualdj.com/plugins/index.html?category=effects&search=autovideotransition
http://www.virtualdj.com/plugins/index.html?category=effects&search=autovideotransition
Mensajes Wed 24 Jan 18 @ 3:28 pm
kradcliffe
Cheers Dan, I have installed it but can't figure out how to activate or configure it.
Edit, copied the .DLL to video transitions but it still doesn't appear to do anything.
Edit, copied the .DLL to video transitions but it still doesn't appear to do anything.
Mensajes Wed 24 Jan 18 @ 3:39 pm
Dan (djtouchdan)
It will appear under master effect > autostart.
Thats where you access the settings.
I use this all the time as the transition only starts the crossfader hits 100% or 0%.
Thats where you access the settings.
I use this all the time as the transition only starts the crossfader hits 100% or 0%.
Mensajes Wed 24 Jan 18 @ 5:51 pm
kradcliffe
Can you please explain how you have it configured, and do you need to have the normal auto video crossfader enabled?
Thanks.
Thanks.
Mensajes Wed 24 Jan 18 @ 6:57 pm
Dan (djtouchdan)
No, disable the standard auto crossfader.
Mensajes Wed 24 Jan 18 @ 9:11 pm
kradcliffe
Thanks Dan, will give it a go at my gig later tonight.
Mensajes Wed 24 Jan 18 @ 9:17 pm