Ingresar:     

Forum: Old versions

Tópico: seting up question - Page: 2

Esta parte del tópico es antigua y puede contener información incorrecta para la nueva versión.

thanks for your hardwork gonna have a go now :)
 
Hope it will went well for ya;)

N do post result or u have any problem just ask.
 
See when connecting the mixer to the mk2 do I still need the mixer connected to the cdj ?
 
No Need.. Just follow the illustration;)
 

Thanks for that spinnaJ,

I'll need that diagram soon, as I will be setting up my 1210's and TCV's up to VDJ when they in stock for us in England. Just one little question though, Where would you attach the grounding cable of the decks, on the herc or on the mixer????

Or doesn't it matter???

Jimmy b



 
ok I have now set it up correctly but when I open virtual dj and go into the settings and click auto - config the program just gets a big error and crashes. the error is the one that says do u want to try and recover
 
jimmy b wrote :

Thanks for that spinnaJ,

I'll need that diagram soon, as I will be setting up my 1210's and TCV's up to VDJ when they in stock for us in England. Just one little question though, Where would you attach the grounding cable of the decks, on the herc or on the mixer????

Or doesn't it matter???

Jimmy b






I ground it at the external mixer..
 
jag4life wrote :
ok I have now set it up correctly but when I open virtual dj and go into the settings and click auto - config the program just gets a big error and crashes. the error is the one that says do u want to try and recover



Have u ticked CD instead of vinyl?

Does this happen everytime u click auto config?

make sure the asio is on (before u start vdj check on herc control panel)

try performances setting, make latency to auto n set to fastest (move this up one by one n see ur system limit).

 
So I keep on vinyl. Yes it crashes when I click cd but when I click vinyl then clcik auto config and it stays at 0%
 

Thanks, spinnaJ mate.

Jimmy b

 
jag4life wrote :
So I keep on vinyl. Yes it crashes when I click cd but when I click vinyl then clcik auto config and it stays at 0%


If u using tccd, do use the cd options. N post ur crash guard txt here after u have the crash.It be located at virtual dj folder at my document.Thnks.
 
CRASHGUARD
date=801181206
version=5.0-Trial
build=500
thread=Main
address=0043caeb
ins=f3ab8b7c
excode=c0000005 (1,6363f00)

 
ok thks.. be back to u.

R the programe still crash?
 
yes it does
 
 
Crash ID=0043c2e8 (date=801181912, version=5.0 rev.4 Trial, build=504, thread=Main, dump=f3ab8b7c, excode=c0000005 (1,62a9240))
 
Can you post screenshot of the timecode config menu in advanced mode with your timecode playing?

Do u use consumer tccd or pro tccd? Try to use the pro as it is -13db n urs is pioneer which tend to have high output.
Have u lower down ur herc volume on the herc control panel or the unit itself? Maximum output may distort the signal.

 
 
jag4life wrote :
have lowered the volume done on the her control panel and the unit



It should be OR not AND. Need to compensate either one.. N is the screenshot u posted r this u already play ur timecodes? Seem u on pause. Could u play the timecode n without auto config n post again. I want to see the wave pattern.

Btw while u change the setting, do u press auto config n crash again.

Sorry if this require a bit of werk as i need to know ur signal.
 
 
74%