Hardware Manuals


Pioneer DJ - DDJ-REV1 - Disposición  

Deck Controls





  1. CUE. When the Deck is paused, you can set a temporary Cue Point by moving the Platter to place the Audio Pointer at the desired location and then pressing the Cue Button. During playback, you can press the Cue Button to return the track to this Cue Point. (If you did not set a Cue Point, then it will return to the beginning of the track.). If the Deck is paused, you can press and hold the Cue Button to play the track from the Temporary Cue Point. Releasing the Cue Button will return the track to the temporary Cue Point and pause it. To continue playback without returning to the Temporary Cue Point, press and hold the Cue Button, then press and hold the Play Button, and then release both buttons.
    Hold down SHIFT and then press this button to return to the beginning of the track.

  2. PLAY/PAUSE. Plays / Pauses the track. Press and hold SHIFT and then press this button to "stutter-play" the track from the last set Cue Point.

  3. JOGWHEEL. Touch sensitive platter for scratching (Vinyl Mode) or bending (CD Mode).
    Press and hold SHIFT and then turn the jog to seek fast inside the track (jog search)

  4. DECK SELECT. Switch Left decks (1 and 3) and Right Decks (2 and 4).
    Press and hold SHIFT and then press this button to toggle the jog between Scratch and Bend Jogwheel modes (Vinyl Mode).
    Press and hold this button to cycle between the available ranges for the PITCH/TEMPO slider (8%, 16% and 50%)

  5. AUTO BEAT LOOP. Sets an Automatic loop where it's length equals the current loop length as seen in VirtualDj GUI. Press the button again to exit the loop.
    Press and hold SHIFT and then press this button to jump back and reactivate the last used loop (Reloop)

  6. LOOP HALF. Halve the size of the current active loop, or the predefined length used by AUTO BEAT LOOP button.
    Press and hold SHIFT and then press this button to set a Loop In point (for manual looping).

  7. LOOP DOUBLE. Double the size of the current active loop, or the predefined length used by AUTO BEAT LOOP button.
    Press and hold SHIFT and then press this button to set a Loop Out point and start looped playback (for manual looping).

  8. SYNC. Press this button to automatically match the corresponding Deck's tempo with the opposite Deck's (or the Master Deck’s if using a 4 decks Skin) tempo and phase.
    Press and hold SHIFT and then press this button to gradually reset the track's tempo back to it's original speed (pitch reset).

  9. TEMPO. Controls the track's playback tempo.
Frente y Atrás