Stems EFFECTS

This section applies Effects on the selected Stems . It is advised to apply the provided silkscreen overlay sticker to get the texts on the DDJ-GRV6 keys as described below.

41. LEVEL. Adjust the 1st Parameter (usually Wet/Dry) of the selected Stems Effect
    
    
42. Stems ARM. Select/Arm the Stems you wish the Effect to apply to.
    Note that these buttons do not mute/isolate the Stems of the Track.
    
    Hold SHIFT down and select the Effect you wish to apply to the armed Stems . The 4 buttons have predefined the Effects Echo Out, Cut, Beat Grid and Delay)
    
    
43. Stems BEAT. Press this button to select 1 beat or 1/2 beat length for the applied Stems FX
    
    Hold SHIFT down and then press this button to select if the Stems ROLL buttons (44) will act as toggle (on/off) or momentary (while pressed)
    
    
44. Stems ROLL. Use these buttons to apply a Loop Roll effect to the armed Stems of Beats values of 1/8, 1/4, 1/2 or 1 beat.
    The trigger behavior depends on the Toggle/Momentary mode you select from the SHIFT+button (43)
    
    Hold SHIFT down and then use these buttons to apply a Cut effect to the armed Stems of Beats values of 1/8, 1/4, 1/2 or 1 beat.
    The trigger behavior depends on the Toggle/Momentary mode you select from the SHIFT+button (43)
    
    
45. Stems FX ON. Use this Latch Lock/On button to enable/disable the selected Effect to the armed Stems